Operating instructions

16
Locate the 2 1/2 “ Dia. flex hose. Find (1)
piece 2’ long. Attach to the face duct over
the left outlet as shown on the picture at
bottom of page.
Route hose up through the hole previously cut in
instrument panel above the gauges.
Locate the Center Louver and attach duct hose as
shown.
Carefully push louver assembly into the opening.
Locate the 2 ½“ Dia. flex hose. Find (2) 3’
pieces. Also locate the (2) louver adaptors from
the Hardware Sack Kit. Attach each one onto
each of the 3’ flex hose. Using (2) #10 x 5/8” pan
head phillips screws.
Attach one of the ducts to the right outlet on face
duct assembly. Route over glove box opening
and push over the passenger outlet.
2 ½” Dia x 2’
LEFT
RIGHT