Operating instructions

15
Route longest of (2) cables that were attached to
the control head, around behind evaporator
assembly and out through upper hole that
original heater was fastened through. Attach this
cable to the water valve.
Set control lever in the Cold position and be sure
that the water valve is closed.
Locate insulation tape and seal around cable at
firewall.
Route shortest of (2) cables and attach to the defrost / heat duct. Insert
cable into second hole from the bottom.
Attach using (1) #10 x 5/8” pan head philips screw.
Reinstall controls into the instrument panel using original hardware.
Locate the Face Duct Assembly. Attach
to the evaporator. There are s-clips on
back edge of the face duct. Make sure
that they slide over the flange on the
evaporator.
Attach using (2) #10 x 5/8” pan head
phillips screws.
#10 x 5/8” pan head philips screw