Operating instructions

13
Locate wire harness from the evaporator electric actuator and
attach to the (2) micro switches. Refer to the wiring diagram
on page 21.
Attach Wire Harness supplied in unit to the blower switch.
Route harness through the control opening. Attach wire harness
to left micro-switch on the Defrost Duct assembly. Route the
harness across top of the unit and hookup resistor, and blower
motor. Route the blue clutch wire over evaporator and out
through hole in the firewall block off plate. Secure ground from
electronic actuator and blower motor using (2) #10 x ¾ “ hex
washer head Tek screw.
REFER TO THE WIRING DRAWING FOR PROPER CONNECTIONS.
Connect power wire
(brown / from original
harness) to the Red /
White stripe from the new
harness supplied.
BLUE WIRE FROM BLOWER
SWITCH
BLUE WIRE TO THE
THERMOSTAT