Operating instructions

11
Attach with (1) ¼ - 20 x 5/8” hex head screw into the J-clip
previously installed. Behind the J-clip you will find an
additional hole in the support bracket. Install a #10 x ¾” hex
washer head tek screw through this hole and into the
cowling.
Locate in the hardware sack kit the evaporator
Support Bracket.
Remove bolt from the instrument panel support
brace and slide Support Bracket behind and
reinstall the bolt.
Attach other end of the bracket to (2) 1/8” Dia.
holes in front of the evaporator using (2) #10 x 5/8
pan head Philips screws.as shown.
Tighten all screws.
Locate Firewall Block Off Plate.
On engine side of the firewall attach over hookup
tubes from the evaporator using (2) #10 x 5/8 “ hex
washer head Tek screws.
Locate insulation tape provided and seal around
hookup tubes as shown.
Water Valve / (3) hose clamps.