Operating instructions

10
Locate Defrost Duct Adaptor from the
Hardware Sack Kit. Place over the
defrost duct that was previously
modified.
Attach using (2) #10 x ¾” hex washer
head tek screws.
Locate Evaporator. Slide evaporator
up into place behind the glove box
opening.
From the engine compartment attach the
evaporator using ¼ - 20 x 5/8 hex head screw with
¼” washer through the 9/32” Dia. hole previously
drilled.
Behind glove box opening attach the blower
support bracket as shown.
¼ - 20 x 5/8” with 1/4 “ WASHER