Installation manual

Time to install the compressor kit. Included in your box is a premium

compressor kit with all the parts you’ll need to install the compressor. This kit

includes instructions specifically written for your engine. Once you’ve installed

the complete compressor kit, continue on to connecting the hoses.

1) Attach the #8 Discharge Hose (13/32") to the connection coming thru the core

support and route to the compressor. Tighten fittings using o-rings and mineral

oil provided.

2) Attach the #6 liquid hose (5/16") to the connection coming thru the core

support and route along the underside of the fender struts, around the engine,

and to the connection at the firewall on the evaporator unit (see figure 41). Using

supplied zip-ties you’ll attach this hose, the suction hose and the lead from the

high pressure switch to the strut braces, securing all three at once. Tighten

fittings using o-rings and mineral oil supplied in kit.

3) Attach the #10 suction hose (1/2”) to the compressor and route as mentioned

above. Tighten fittings using o-rings and mineral oil supplied in the kit.

Fender Struts

FIGURE 37

COMPLETE

COMPRESSOR

KIT