Installation manual

FIGURE 23

#10 - 16 x 3/4" Tek Screw

FIGURE 22

The second 1/4 - #20 x 5/8" bolt attaches the blower motor mounting

bracket in the same location as the original heater mounting in front of the Air

Inlet. The blower support bracket will have an additional hole behind the 1/4 -

#20 x 5/8" Bolts. Install a #10 - 16 x 3/4" Tek screw through this hole and into

the cowling (see figure 22).

Locate in the Bag Kit B the Evaporator Mounting Bracket and attach to

evaporator unit using two #10 - 10 x 5/8" Phillips screws. Attach other end to

the cowling with a #10 - 16 x 3/4" Tek Screw (see figure 23). IMPORTANT

NOTE: On the side of the main unit you will see several holes for

mounting holes... ONLY USE THE ONES IN THE CENTER FOR THIS

BRACKET! Do not tap into the other holes for any reason (see figure 24).

Also, use a screwdriver and hand-power and do not over-tighten so you

don't strip the holes.

FIGURE 24

YES

NO!

#10 x 5/8"

Screws