Installation manual

Take a minute to familiarize yourself with the evaporator unit:

Evaporator

Support Bracket

Holes

Blower Motor Plug

Thermostat

Actuator Motor

Blower Motor

Bracket

Floor/Face

Vent Door

Locate the Fresh Air inlet block off. Install over hole in inlet cowl as shown on

the passenger side (see figure 17A). Attach with three #10 - 16 x 3/4" Tek

Screws. Locate the mounting tab location as shown and attach the 1/4" 20

J-clip supplied (see figure 17B).

Remove evaporator unit from box and place on a flat work surface.

Locate defrost / heat duct assembly and attach to the evaporator using two

#10 - 10 x 5/8" Phillips screws (see figure 18). NOTE: Be sure that the s-clips

are pushed over rear flange on evaporator.

FIGURE 17

FIGURE 18

FIGURE 19