Installation manual

11
OEM Screw
TEMP
Preparing the TEMP EZ Cable Integrator for
installation:
First place a cable clip over the end of the
Integrator (see figure A). Press it firmly into place
(using needle-nose pliers is recommended).
Hook loop end of integrator wire over the end of
the control head lever, see figure B.
Using the OEM screw mount the integrator to the
control head pedestal as shown in figure D. Make
sure orientation is correct, using figure C as a
guide.
Securely fasten wire end with a push nut (see
figure E).
Lastly, move LOWER lever side to side
making sure you have smooth
operation of the cable integrator.
Figure C
Figure D
Figure B
Figure E
Figure A