Installation manual
26
FIGURE 32
Bag Kit G: Installing the center louver vent requires some cutting to the upper pocket slot in the center dash area. Your goal is to open
the back enough to insert the included center louver unit into the hole and then attach the flex hose. Use a hole drill bit and open it up a
bit at a time (see below). Use the new center louver as a guide to see when you’ve cut-away enough material.
Once the hole is the right size, insert the new center louver and attach the flex hose using ty-wraps to secure. Route to the face/floor
asembly on the evaporator.
As you cut the hole thru the dash, keep the new center
louver handy and test fit occasionally.
GOOD IDEA
WWWCLASSICAUTOAIRCOMs866.435.7801
9LTV]L[OPZ
HYLHRLLWLKNLZ
ZTVV[O
CAA 2028 Installation.indd 26CAA 2028 Installation.indd 26 4/2/12 9:58 AM4/2/12 9:58 AM