Installation manual
14
Take a minute to familiarize yourself with the evaporator unit:
Evaporator
Support Bracket
Holes
Blower Motor Plug
Thermostat
Actuator Motor
Blower Motor
Bracket
Floor/Face
Vent Door
Locate the Fresh Air inlet block off. Install over hole in inlet cowl as shown on
the passenger side (see figure 18A). Attach with three #10 - 16 x 3/4" Tek
Screws. Locate the mounting tab location as shown and attach the 1/4" 20
J-clip supplied (see figure 18B).
Install a Fresh Air inlet block off over the vent opening at the drivers-side in the
same way, using the four OEM nuts.
Remove evaporator unit from box and place on a flat work surface.
Locate defrost / heat duct assembly and attach to the evaporator using two
#10 - 10 x 5/8" Phillips screws (see figure 19). NOTE: Be sure that the s-clips
are pushed over rear flange on evaporator.
Remove ECU from main unit and set aside.
FIGURE 18
FIGURE 19
A
B
WWWCLASSICAUTOAIRCOMs866.435.7801
CAA 2028 Installation.indd 14CAA 2028 Installation.indd 14 4/2/12 9:57 AM4/2/12 9:57 AM