Installation manual
11
FIGURE 11
FIGURE 13
MODE Control
TEMP Control
Attaching our exclusive cables to the
control head is accomplished in three easy
steps: Step 1) slide the include cable clips over
the ends of the of the EZ Integrators (as shown
in figure 11) then, Step 2) attach the integrators
to the OEM control head base with the OEM
screw you removed earlier, overlapping the
cable clamps (see figure 12). Step 3) push the
integrator wire ends over the ends of the levers
(see figure 13).
Once you have completed these steps, you
have just one quick task to do before you can
reinstall the control head back into the dash.
We’ve included a new face sticker that
corresponds to the actions of your controls.
Make sure the surface is clean and oil free,
peel off backing and stick the sticker to the
control head face.
Plug in the blower switch, and insert the entire
harness and control head back into dash
opening, resecuring with OEM screws.
OEM Screw
FIGURE 12
NOTE: The cable clips will overlap and use
the same hole and the single
OEM screw
WWWCLASSICAUTOAIRCOMs866.435.7801
CAA 2028 Installation.indd 11CAA 2028 Installation.indd 11 4/2/12 9:57 AM4/2/12 9:57 AM