Owner`s manual

37
3 CAN-Bus Terminator
ACAN-BusTerminatorwillberequired.ItisinsertedintotheCAN-Bus
OUTconnectorofthelastcomponentintheCAN-Busdaisychain.One
is includedintheboxwithyourCP-800.T hey are also available free of
charge from your nearest Classé Customer Support Center
http://www.Classeaudio.com/support/service.htm
ediagrambelowillustrateshowtoconnecttheCAN-Bushardware.
Any combination of models in any order.
NOTE: Daisy chain must be terminated with CAN-Bus Terminator.
using CAN-Bus CAN-BusiscontrolledviathetouchscreenofanyDeltaorCTseries
component.ereisnomastercomponent,soDelta/CTseriessystemswhere
two or more units have a touchscreen can be controlled through any of the
touchscreens.However,itisprobablyeasiesttostartusingCAN-Busthrough
just one.
CAN-Busisaccessedbypressingthemenu button on the face of the unit or
remote, then the status button, followed by the button.
e touchscreen will then display the CAN-Bus devices screen, which lists
connectedDelta/CTseriescomponentsbymodel&serialnumber.
Highlighting aunitontheCAN-Busdevicesscreenidentiesitasthetarget
unit. e front panel LEDs of the target unit will start ashing (unless you
highlighttheunitthatyouareusingtoaccessCAN-Bus).
Once you have chosen the target unit press select.etargetunit’sLEDswill
stopashingandthetouchscreenwilllisttheCAN-Busfeaturesavailabletoit.
SomeCAN-Busfeaturesaresharedbyallmodels,somearespecictoindividual
models.