Owner`s manual

35
Balance ToadjusttheL/RBalance,whenontheBalancepage,usethevolumeknobor
the volume up/down keys of the remote control. Balance is adjusted in 0.5 dB
increments by alternately boosting and cutting 0.5 dB from each channel. In this
way, the overall level stays roughly the same as the balance shifts. e Balance
control works by making adjustments with the master volume control, so no
additional circuitry enters the signal path when balance adjustments are made.
e Balance control oers a range of +/- 10.0 dB and moving the control to
either extreme turns o the opposite channel (used mostly for troubleshooting).
NOTE: Your L & R speakers may not produce the exact same
output for a given input, or their location in the room or relative
to your listening position may contribute to a perceived imbalance
of up to a few dB. To compensate for this, play a simple vocal
recording and put the CP-800 in Mono (press Menu, then Mono).
Open the Balance control page and using the remote, adjust the
balance until the sound image is perfectly centered. If you close
your eyes and do this a few times, you will nd that one number,
like Right 1.5 dB, may appear consistently. If so, you know that is
the adjustment your system requires. Leave the setting there, return
to normal stereo operation and then forget all about the balance
control.
Configurations You may create up to six dierent output congurations to accommodate
preferences like with or without subwoofer(s), or with subwoofer(s) having
dierent crossover settings. While these congurations may be associated with
specic sources, they may also be called from the Main Menu page or the remote
control. Pressing the Congurations button in the Main Menu or choosing
Cong Select on the remote opens the Congurations page. Choose the
conguration you wish to employ.
Tocustomizecongurations,seetheCongurationSetupdescriptioninthe
System Setup section.
Mono Pressing the Mono button combines L & R channels, resulting in monaural
output on all channels (including Auxiliary and subwoofer channels). When in
Mono, the Mono button is shaded. Press again to deselect and return to normal
stereo operation. When in Mono, the word Mono appears in a box on the Home
page.
Status e Status screen provides several items of information on the currently selected
source and conguration as well as access to information on the rmware used
in and the internal settings and sensors of the CP-800. While on this page,
pressing the more button will access the CAN-Bus features for connected Classé
components.