Owner`s manual

29
Timeout If you prefer listening to music in a dimly-lit or darkened room, you may
nd even the low brightness setting of the display somewhat distracting. You
can essentially turn o the touchscreen by reducing the timeout value of the
backlighting so as to turn it o entirely after a period of inactivity that you
may select. In this context, activity refers to any use of the user interface. is
includes hard buttons, the touchscreen, and the remote control.
For example, if you reduce the timeout to its minimum setting, the backlighting
illuminates the display as soon as you interact with any of the CP-800 controls,
and remains lit for only three seconds – just long enough for you to check a
setting. If you continue to use any of the controls (at least once every three
seconds), the display remains lit. After three seconds of inactivity on your part,
the backlight extinguishes itself, essentially turning o the touchscreen.
If you prefer the display of the CP-800 to remain on whenever not in Standby
mode, select the Never timeout option. e lamp in the touchscreen display is
designed for harsh automotive environments and will give you many years of
reliable operation. If you plan to leave the unit on continuously, however, we
recommend that you keep the timeout delay set to less than one minute.
NOTE: setting the brightness to a lower setting does not increase
the life of the lamp.
Volume Setup TouchingtheVolume Setup button in the System Setup menu opens the
Volume Setup page, as shown below. e volume knob is used to make all
volume setup adjustments.
Volume Setup allows you to:
• setamaximumvolumelevel
• chooseaninitialvolumelevelforthesystemwhenevertheCP-800is
brought out of Standby
• customizethebehaviorofthemutecontrol