Owner`s manual

28
Auxiliary Channels e CP-800 has two auxiliary channels that can be utilized for bi-amping the
L&R speakers. Alternatively, Aux 1 may be used in conjunction with the Sub
output to provide a second mono subwoofer or stereo subwoofer conguration.
If either the single-ended or balanced Aux channel outputs are enabled and no
more than one subwoofer is being used, then the aux channels are considered to
beactiveinbi-ampmode.Technically,thisiscalledpowerbiamping.Separate
amplier channels are used for the high and low frequency drivers of your
loudspeaker, but the passive crossovers in the speaker do the work of ltering low
and high frequency signals. In this mode, the two auxiliary channels produce the
same output as the Main Left and Right channels.
NOTE: When bi-amping with two dierent ampliers on each
speaker, the ampliers must have the same gain in order to ensure
proper level matching between the upper and lower frequencies. All
Classé Delta and CT series ampliers have the same gain and may
be used in any combination for bi-amping.
Display Setup e Display Setup menu page, shown below, allows you to congure the
brightness and display timeout used for the touchscreen display.
Brightness e Brightness setting of the CP-800 touchscreen has three possible values: low,
medium, and high. Select the setting you prefer. A high brightness setting usually
worksbestinbrightly-litrooms;youmayndthatalowersettingislessvisually
intrusive under more subdued lighting conditions.