Owner`s manual

Configuration Setup e Conguration Setup page allows you to dene up to six dierent speaker

congurations.Touchthebuttonforthespeciccongurationyouwanttoset

up to open its conguration setup menu. e page contains buttons for naming

the conguration and enabling balanced (XLR) and single-ended (RCA) outputs

for Main, Aux and Subwoofer channels. Choosing a subwoofer output causes

a Bass Management button to appear. e same menu is used to set up each

conguration.

Configuration Name Aswithnamingsources,presstheCongurationNamebuttontoaccessthe

keyboard used for customizing the conguration name. Remember to press Enter

after making your changes to save the new name.

Configure Outputs Choose the output connectors you want enabled with this conguration. If a

subwoofer (or two) is used, a Bass Management button appears, allowing you to

set crossover frequency and slope, or enable stereo or two mono subwoofers.

If you also want to High-Pass Filter the L&R outputs, check the box for L/R

HP Filter. e crossover will pass the higher frequencies and correctly direct

the low frequencies to the subwoofer(s) based on your frequency and slope

settings. If this box is unchecked, L&R channel signals pass full range and the

lower frequencies are duplicated by the subwoofer(s). is may result in too

much bass, especially at certain frequencies, so equalization may be required to

compensate.