Owner`s manual

25
From the System Setup menu, you can:
• tailoryourinputstoyourparticularsourcecomponents
• congurethesystemtotakebestadvantageofyourloudspeakers
• tailorthedisplaytoyourpreferences
• setvolumecontrolparameters
• enable and setup the Parametric EQ
• setupToneControlparameters
• teach IR commands
• choose Remote F key functions
• assign DC triggers
Source Setup Each of the 18 source buttons supported by your CP-800 can be customized in
several ways to enhance system performance or to simplify operation. e source
select page is dynamic in that it shows up to nine sources on a single page. If six
or fewer are enabled, then the page shows six somewhat larger buttons and if
three or fewer are enabled, it shows only three large buttons. Press the button for
the source you want to set up. e setup page for that source includes buttons
for assigning the input connector(s) and naming the source, choosing a default
speaker conguration, setting an input oset, selecting the Pass-ru feature or
choosing the Analog Bypass path.
Enable Source is check box activates/deactivates source buttons. If the Enable Source box is
checked,thenthesourceisenabled.IftheEnableSourceboxisNOTchecked,
then the source is considered not enabled and is so identied on the source
selection page.
Disabling unused sources is a good way to simplify source selection. e Source
select page is dynamic, adjusting the number and size of buttons to correspond
to the number that are actually being used or enabled. e buttons arrange
themselves into groups of either three, six or nine buttons on the Source Select
page.
Input Connector Choose the input connector(s) to be associated with this source button. Any
source button may be associated with any input connector(s). Also, multiple
source buttons may be assigned to the same connector(s).