Owner`s manual

22
Using the CP-800
eCP-800’sversatiletouchscreenLCDsupportsyourday-to-dayoperations
and provides access to a exible menu system for controls and setup functions
thataren’taccessedasoften.issectionoftheowner’smanualoutlinestheuse
of the touchscreen in routine operation of the system.
When you bring the CP-800 out of Standby mode, the touchscreen displays the
Home page of the menu system, as shown below.
e Home page displays the volume in large font which is easily visible from
across a room. e selected source appears at the bottom of the screen. At the
bottom center of the screen the format of the incoming signal is displayed. is
displays the sampling frequency of digital sources or Bypass if so selected for
analog sources. If and Pass-ru is selected for either digital or analog sources,
the volume display will read 0.0 and be greyed out (since the volume control
is not active in this mode).. is page can be quickly accessed at any time by
pressing the Home button on the remote control or tapping the home icon on
the touchscreen display.
source selection TouchingthescreenwhenontheHomepagebringsuptheSourceSelection
page. e number of source buttons appearing here corresponds to the number
of inputs that have been set up and are “enabled.” A maximum of nine sources
may appear on one page. If more are enabled, they will be available on the next
page by touching the button in the upper right corner of the page. See the
section on source setup in the Menu System. e CP-800 has up to 18 selectable
source buttons which are all interchangeable.