Owner`s manual

21
When connecting a cable, make sure the cable has a good connection and is
rmly attached to the rear panel connectors on both the amplier and the
CP-800.
e CP-800 also provides two Auxiliary analog audio outputs. See the section
on Conguration Setup for more details about the Auxiliary outputs. If used,
connect the AUX output(s) to its corresponding amplier(s) or subwoofer.
Step 5 Connect the loudspeakers to the amplifiers.
Important! Verify that the power amplifier(s) is plugged in but powered
OFF before connecting to the CP-800
Connect each loudspeaker to its designated amplier(s) channel. Pay close
attention to the phase of the speaker connections – always connect an amplier’s
red (+) terminals to the red (+) terminals of the loudspeaker. Likewise, connect black
(–) terminals to black (–) terminals.
Step 6 Power up the system!
NowyouarereadytopowerupyourCP-800andyouraudiosystem.
• TurntherearpanelpowerswitchoftheCP-800toON e Standby
LED will turn red.
• PressthestandbybuttonlocatednexttotheLED. e initial power-
up cycle of the CP-800 takes a few seconds.
• Whenthepower-upcycleiscomplete,theCP-800entersOperate
mode and the touchscreen becomes active.
• PresstheStandby button to toggle the CP-800 into and out of
Standby.
e physical setup of the CP-800 and system components is complete.