Owner`s manual

18
5 Navigation & Menu Buttons
e remote control contains the navigation buttons and the menu access
buttons. is array of buttons is used for navigating the menu system on
the CP-800 as well as providing basic transport controls to USB-connected
sources. Each of the buttons performs the following function(s):
• Menu accesses the main screen for the menu system, in the same
fashion as the front panel Menu button.
• Home returns the touchscreen display to the Home page. e
Home button essentially acts like a “back to start” button – no
matterhowdeeplyyou’venavigatedintothemenusystem,a
single button push returns you to the front page.
• Navigation Arrows are located in the familiar Up (p), Down
(q), Left (t), and Right (u) arrow positions which allow you
to select the dierent menu options within the menu system.
When on the home page, these buttons instead serve as transport
controls for USB sources with the typical play/pause, stop, scan/
skip forward and scan/skip backward commands.
• PressingtheEnter button selects the underlined menu item in
any menu screen.
• ToneaccessestheToneControlscreen.PressingTonewhileon
theToneControlscreenactivesthetonecontrol.Subsequent
pressestogglebetweenactiveandnotactive.WhileontheTone
Control screen, the volume up/down keys increase or decrease
thetonecontrol.SeeToneControlSetupintheMenuSystem
section for more information.
• Bal is used to access the Left/Right balance. Use the Volume
arrows to adjust the L/R balance.
6 Function Keys (F1 to F8)
e last eight buttons on the remote control are the Function buttons, or
Fkeys, which provide additional exibility to the CP-800 remote control.
ink of them as “favorite” buttons that provide direct access to specic
functions or commands not covered by the other buttons. Refer to the
Remote Fkeys description in the Menu System section found later in the
manual for more information.