Owner`s manual

15
8 IR Output
Use the IR output to pass IR commands from an external IR transmitter
through the CP-800 to another component, when necessary. e output
uses a mono mini-jack (3.5mm phono) with the same properties as the
diagram in the previous section.
9 Trigger Outputs
e CP-800 supports two trigger outputs, with mono mini-jacks (3.5mm
phono)labeledOUT1andOUT2.Eachtriggeroutputsa12VDCsignal
at 100 mA and each can be controlled individually. Use these outputs to
control other system components such as ampliers and window blinds.
Refer to the Triggers description in the Menu System section for more
details.
10 RS-232 Port
e primary purpose of the RS-232 port is to support the use of external
commands to allow remote control of the CP-800 by such systems as
AMX
®
, Control 4 and Creston
TM
. For more information about these
systems, contact your Classé dealer.
11 CAN-Bus Input and Output
CAN-Bus(ControllerAreaNetwork)allowsseveralClassécomponentsto
be connected together for simultaneous operation, such as switching from
On to Standby.UsingtheCAN-BusInputandOutputconnectors,the
Classé components can be daisy chained together and controlled via the
CAN-Businterface.
NOTE: e nal component in the daisy chain MUST have a
termination plug inserted into the CAN-Bus output.
Formoreinformation,refertotheCAN-Bussectionfoundlaterinthis
manual.
12 Analog Outputs
e CP-800 supports ve analog audio outputs, with both balanced (XLR)
and single-ended (RCA) connections. Connect the Main R and Main L
outputs to the Right and Left amplier channels respectively.
e Aux 1 and 2 outputs are congurable and can be used for the
following purposes:
• AssignedtomirrorthemainL/Rspeakersforuseinapower
biamplication arrangement.
• AUX1maybeassignedasanadditionalsubwoofertobeusedin
conjunction with the Sub output congured as either two stereo
or two mono subs.