Owner`s manual

Front Panel

e front panel of the CP-800 is shown above. e numbers in the drawing

refer to the descriptions that follow.

1 Standby/On Button and Status Indicator LED

Pressing the Standby button puts the CP-800 into standby mode – a

low-power state which leaves the preamp/processor and outputs inactive

but still allows the unit to respond to system commands via any of the

supportedcontrolprotocols(IRinput,CAN-BusorRS-232).

If the unit is already in Standby mode, pressing the Standby button fully

powers up the unit.

• LEDOn(Red)–theCP-800isinStandbymode.

• LEDturnscyan,thengreen,theno–theCP-800isinthe

process of power-up initialization.

• LEDOn(Blue),indicatestheunitisintheoperatemodeand

the display timeout setting has been activated.

•

LED O – the CP-800 is powered on, fully operational, and the display

active If the display is not active and the LED is o, then the CP-800 is

not getting AC power.

2 Menu On/Off Button

Press once to call up the main page of the menu system, which replaces

thenormalfrontpageorHomepageoftheTouchscreen.PresstheMenu

button again to revert to the Home page.

e menu system gives you control over operational details including:

system setup options, various display options, and custom installation

capabilities so that the CP-800 integrates smoothly into the most complex

systems. For more information, see the Menu System later in this manual.

3 Touchscreen

e front panel touchscreen is used for day-to-day operation of the CP-

800. It is also used for setup and to display useful information as required.

CP-800

MUTE

3 5