Owner`s manual

OMICRON ISSUE 2 DEC ‘98
-
5
-
GENERAL CONNECTIONS
A.C. LINE
Insert the 2 linecords into the A.C. receptacle on the rear of the unit. PLEASE MAKE
SURE YOU HAVE PREVIOUSLY HOOKED UP THE SPEAKERS AND PREAMPLIFIER
TO YOUR AMPLIFIER BEFORE CONNECTING THE AC POWER CORD TO THE
AMPLIFIER.
IMPORTANT NOTE
CAUTION: SAFETY INSTRUCTIONS
DISCONNECT THE 2 AC LINE CABLES BEFORE MAKING ANY OTHER
CONNECTIONS. "FLOATING THE GROUND” OR DEFEATING THE GROUND ON A
3-PRONG LINECORD MAY CREATE A SHOCK HAZARD. CONNECT ALL INTERCON-
NECT CABLES BETWEEN THE ELECTRONICS BEFORE CONNECTING THE A.C.
LINECORDS TO THE WALL OUTLETS. THIS WILL REDUCE THE POTENTIAL SHOCK
HAZARD.
STEREO
Input and output connectors are clearly marked on the back of the amplifier. Left/Right
connections are oriented from the front of the unit. Stereo output connections are marked above the
connectors. Switch stereo/mono switch to STEREO position. (The OMICRON is preset at the
factory for STEREO.)
Use only high quality interconnect and loudspeaker cables, and make all connections tight. If
the RCA input plugs are loose, remove them and pinch down the ground leaves slightly with pliers.
Observe correct phasing of the loudspeaker connections, and tighten.