Owner`s manual

OMICRON ISSUE 2 DEC ‘98

UNPACKING & SET-UP

Your CLASSÉ OMICRON power amplifier is packed in high density, semi-rigid foam

placed in a special Fiberglas case. To remove the unit, put the fibreglass case with the Classé

lettering right side up. Unlock the four (4) case locking devices by first lifting the tabs, and turning

them fully counter clockwise. Then, pull the tabs; the locking devices will pivot downwards. You

can now remove the large top portion of the case. Take the unit out of the base of the case and

remove the plastic bag and inspect the unit for any concealed damage. Apart from the owner's

manual, please ensure the following has also been included:

1) Two (2) detachable A.C. linecord

2) Nut driver for output connectors

Please report any damage or missing parts to your dealer immediately.

Place the OMICRON at or near its final set-up position, allowing 8 inches at the rear for

tightening the speaker output connectors.

The power transformers in the OMICRON are located at the front-center of the unit.

Ideally, a few feet should separate this area from components which potentially could pick up hum.

These include preamplifiers, turntables, and interconnect cables. In terms of providing adequate

airspace for cooling, a good rule of thumb is to allow 6 inches above and 3 inches on each side of the

unit.

Check the Serial Number sticker on the back of the unit for the correct operating voltage.

The OMICRON has two external AC fuses, the rating of which should be as follows:

LINE VOLTAGE FUSE RATING

100 or 120 V.A.C. 2X 15 AMP SLOW BLOW, 125 or 250 volts

220 or 240 V.A.C 2X 12 AMP SLOW BLOW, 250 volts