User`s guide

APOGEE ELECTRONICS

Mini-DAC – User’s Guide

APOGEE ELECTRONICS

Mini-DAC – User’s Guide

1. Remove the two TOP screws from the

Mini-DAC front panel, using a 1/16” hex wrench.

2. Remove the two TOP rear panel screws, and

LOOSEN ONLY the bottom two rear panel screws

and the eight connector mounting screws.

3. Pull the rear panel back (without removing it)

to provide clearance for the USB Option Card

connecter.

4. Insert the USB Connecter (on the USB Option Card)

into the square cutout of the Mini-DAC rear panel,

ensure that connector pins under the card are

properly aligned (indicated at right), and gently press

the Option Card into place.

5. Secure the Option Card by installing the two provided

screws in the locations indicated. Re-install the

Mini-DAC Top Cover.

INSTALLING THE USB OPTION CARD