Owner`s manual

1.1.6 PANEL INFORMATION DISPLAY
The two lines of information displayed, and the lit
LEDs on the face of the SSP-75 combine to provide
a comprehensive view of its current operating
parameters. All set-up procedures may also be
performed utilizing only the panel display, though it
is easier using the onscreen OSD method. The first
line displays the SOURCE on the left and selected
MODE on the right. ‘THX’ is displayed in the middle
of this line when you use the remote control wand
to select THX playback for any SOURCE.
The second line displays on the left where the
currently connected audio input, and the output
level, (or ‘Mute’) is displayed on the right end of
the line.
While the Remote Zone is being accessed the word
‘ZONE’ appears in the middle of lower line, and all
the information displayed in the window relates to
the operation of the Remote Zone. The layout of
the information is the same as above.
1.1.7 MEMORY BUTTON
The purpose of this button is enable quick
memorization of the current setup of the playing
SOURCE. The audio input and selected format are
memorized along with any video input. The next
time the SOURCE is selected the setup will be the
same. (Any previously memorized settings for the
SOURCE are erased).
1.1.8 MUTE BUTTON
This button fully mutes the SSP-75’s main outputs
and also can be used to mute the Remote Zone
outputs when Remote Zone control is activated. A
second push of the Mute button restores the
previously selected operating levels. Record output
is always unaffected. The Mute button provides a
convenient way to instantly lower the volume when
answering the telephone.
NOTE: Turning the volume up with the volume
knob (or remote control wand), will remove muting,
but turning down the volume while in mute mode
will not remove muting. However; if you reduce the
volume while the audio output is muted, when
muting is removed the new lower volume level will
be present. (There is no indication of the volume
change on the panel display. If you are using a
video output with OSD the reduced volume will be
displayed briefly while the volume is being
reduced). Muting can be removed either with the
mute button or by turning up the volume slightly.
1.1.9 MASTER LEVEL CONTROL
This large knob changes the levels of all the active
channels in either the main room or the remote
zone. In the main room each loudspeaker’s relative
loudness stays in perfect balance with all other
speakers as programmed during setup. The Main
Information Display shows the master level setting
in numbers from ‘-80’ (virtually no output) to ‘+30’
(maximum output).
5