Manual

19
Class 1 Valve Manual
p/n: 119138
5.4.3 SPS Electric Valve Controller Connection Description
The module has one connector and the following definitions apply:
Mating connector: AMP 794781-1
Mating terminals: AMP 770988-1
Seal: AMP 794772-0
Wire seal: AMP 794758-1
Cavity plug: AMP 794995-1
Recommended wire gage: 18-26 AWG
PIN
DIR
CIRCUIT
DESCRIPTION
1
◄
IN
Supply (+)
Vehicle power (positive, +12VDC to +32VDC)
2
----
Not used
3
----
Not used
4
►
OUT
Reference (+)
Valve position supply reference (positive, +5VDC)
5
◄
IN
Position signal
Valve position signal (analog, 0-5VDC)
6
----
Not used
7
----
Not used
8
►
OUT
Valve motor A
Valve direction control (± polarity, direction based)
(1)
9
►
OUT
Valve motor B
Valve direction control (± polarity, direction based)
(1)
10
◄
IN
Supply (-)
Vehicle power (ground)
(1)
CLOSE = positive polarity Valve motor A, ground polarity Valve motor B
OPEN = ground polarity Valve motor A, positive polarity Valve motor B
Connector pin position detail (SPS view).
5. installation