Owner manual

Service Menu

SERVICE MENU

MENU DEG: (CLNT / OIL) SELECT toggles source for temperature information

MENU SETPOINT SELECT LO is displayed on the OIL PRESSURE display

LO ALARM SELECT low oil pressure alarm (0-20 PSI)

Press the select switch first and then the silence switch, hold both for 1 second and

then release select first and then silence to save data

MENU SETPOINT SELECT HI is displayed on the ENG TEMP display

HI ALARM SELECT high temperature alarm (200-250

Press the select switch first and then the silence switch, hold both for 1 second and

then release select first and then silence to save data

MENU SETPOINT SELECT LO is displayed on the VOLTS display

LO ALARM SELECT low voltage alarm (10.0-13.0 VDC)

Press the select switch first and then the silence switch, hold both for 1 second and

then release select first and then silence to save data

MENU SETPOINT SELECT HI is displayed on the VOLTS display

HI ALARM SELECT high voltage alarm (13.0-17.0 VDC)

Press the select switch first and then the silence switch, hold both for 1 second and

then release select first and then silence to save data

MENU PTO SVC SELECT Ack Req? clear the PTO SVC Message

depress SELECT & MENU, release SELECT to save.

Display will read NS=xxxx, where xxxx indicates when the next ser-

vice is due.

To enter the Service Menu, engine RPM can not be greater than 900.

Press the switches in this sequence.

SILENCE : SELECT : SILENCE : SILENCE : MENU

Scroll through menu items by pressing the MENU switch.

Select items from the menu by pressing the SELECT switch.

After Selection, change items by pressing the

SELECT switch.

Save information and exit from the menu by pressing the

SILENCE switch unless noted.

* You must save any changed item before moving on in the menu!