Owner manual

ManualsBrandsClass1 ManualsCarDigital Aerial Warning Display

page 1 of 6 pages

Engineering

Standards

Name Digital Aerial Warning Display

Identifier Installation Information

Engineering Standard Number

C1-102342-A

Installation

The display mounts in a 2.84” by 1.51” cutout.

Overall area necessary for installation is 3.2” by 2.5”.

Two 0.201d holes are provided for mounting screws.

2.840"

.277

1.510

.470 1.900

Ø 0.201"

(2) HOLES

Summary of content (6 pages)

PAGE 1
Engineering Standards Name Digital Aerial Warning Display Identifier Installation Information Engineering Standard Number C1-102342-A Installation The display mounts in a 2.84” by 1.51” cutout. Overall area necessary for installation is 3.2” by 2.5”. Two 0.201d holes are provided for mounting screws. 2.840" 1.510 .277 Ø 0.201" (2) HOLES .470 1.
PAGE 2
Engineering Standards Name Digital Aerial Warning Display Identifier Installation Information Engineering Standard Number C1-102342-A 3.125" 0 25 50 75 100 2.462" DIGITAL DISPLAY 0.285" 3.
PAGE 3
Engineering Standards Name Digital Aerial Warning Display Identifier Installation Information Engineering Standard Number C1-102342-A Electrical The Aerial Warning Display is connected to the OEM harness with a Deutsch 8 pin mini-connector. Mating Connector: Locking Wedge Mating Terminal: DTM06-08S WM-8S 0462-201-20141 20 gauge socket PIN 1 2 3 4 5 6 7 8 12 VDC Display Power P.N.
PAGE 4
CIRCUIT 10 VDC SIGNAL 2.5' 5' 2.5' Dual Display Wiring CIRCUIT SIGNAL 1 SIGNAL 2 XDucer IN V IGN GND -T V+ -- 12" 12" Installation Information Turntable or Reel 2.
PAGE 5
Engineering Standards Name Digital Aerial Warning Display Identifier Installation Information Engineering Standard Number C1-102342-A Calibration for dual and single transducer installations: Calibration for Gauges with bargraph displays The calibration mode is entered by the use of a “password”. There are two magnetic switches, one located at each side of the display. These switches are activated with the use of a magnet.
PAGE 6
Engineering Standards Name Digital Aerial Warning Display Identifier Installation Information Engineering Standard Number C1-102342-A Operation 0 25 50 75 100 LOW LEVEL LOADING The Class1 Aerial Loading Display is designed to warn aerial operators of dangerous loading conditions when an aerial device is operated at low angles of elevation. Live loads (factors that increase this load such as ice, occupants on the ladder, water load, extra equipment, etc.