Product Info

MORLAB
Shenzhen Morlab Communications Technology Co., Ltd.
FL1-3, Building A, FeiYang Science Park, No.8 LongChang Road,
Block67, BaoAn District, ShenZhen , GuangDong Province, P. R. China
Tel: [phone] Fax: [phone]
Http://www.morlab.cn E-mail: [e-mail]
REPORT No.：SZ21070039S02
Page 26 of 53
Fig 9.1 Illustration for Body Worn Position
9.3. Hotspot Mode Exposure Position Conditions
For handsets that support hotspot mode operations, with wireless router capabilities and various web browsing
functions, the relevant hand and body exposure conditions are tested according to the hotspot SAR procedures
in KDB 941225. A test separation distance of 10 mm is required between the phantom and all surfaces and
edges with a transmitting antenna located within 25 mm from that surface or edge. When the form factor of a
handset is smaller than 9 cm x 5 cm, a test separation distance of 5 mm (instead of 10 mm) is required for
testing hotspot mode. When the separati
on distance required for body-worn accessory testing is larger than or
equal to that tested for hotspot mode, in the same wireless mode and for the same surface of the phone, the
hotspot mode SAR data may be used to support body-worn accessory SAR compliance for that particular
configuration (surface).
Fig 9.2 Illustration for Hotspot Position