User Manual
NOTICE TO INSTALLER: Instructions must remain with installation.
All Clarus Environmental products must be installed and maintained in accordance with all applicable codes.
Product information presented here reflects conditions at time of publication. Consult factory regarding discrepancies or inconsistencies.
© Copyright 2011. All rights reserved.
Fig. 1
Fig. 2
Fig. 3
Fig. 4
APPLICATION
Use the Filter Sock in conjunction with the Clarus
Environmental WW4 Efuent Filter P/N 5000-0007
to reduce particle size to a maximum of 1/32".
INSTALLATION
1. Remove the primary lter assembly from the
Clarus Environmental WW4 lter assembly.
2. Place the primary lter assembly down into the
Filter Sock (see Fig. 1).
3. Loop one end of the string around the lter
holder post and tie the lter sock above the lower
rim of the lter holder (see Fig. 2 and Fig. 3).
4. Press excess Filter Sock in between lters (see
Fig. 4).
5. Place the primary lter assembly back in the
Clarus Environmental WW4 housing.
6. Recommended peak ow through the lter
is 1500 GPD. Multiple WW4 lters may be
manifolded together for installations requiring a
greater ow rate (see Fig. 6).
SECTION: C2.20.140
CL0132
1011
Supersedes
New
®
®
3649 Cane Run Road
.
Louisville, KY 40211-1961
877
-
244
-
9340
.
Fax: 877
-
414
-
4316
www.clarusenvironmental.com
WW4 Filter Sock
WW4 FILTER SOCK INSTALLATION INSTRUCTIONS