Owner manual

ManualsBrandsClarus Environmental ManualsPumpsTurbine STEP Systems

HIGH WATER ALARM

TIMER OVERRIDE

5" MIN.

LOW LEVEL CUTOUT

8" MIN.

REDUNDANT OFF

5" MIN.

30.5" MAX.

TIMED DOSING WITH REDUNDANT OFF

3.5" MIN.

(1" ADDED FOR SAFETY)

SEPTIC TANK MIN. INLET HEIGHT 41"

TOP OF FLOAT TREE

NYLON CABLE TIE

TOP OF FILTER HOLDER

TO THE FLOAT TREE USING TAPE OR

FLOAT CORD HOLDER MUST BE ATTACHED

NOTE: IN ALL CASES. THE LOOSE CORD ABOVE

NYLON WIRE TIES.

NOTE: FLOATS ARE 90° OPPOSED AND

LOCATED OPPOSITE THE INSIDE

WALL OF THE PUMP VAULT.

3 1/2" TETHER

FLOAT

CORD HOLDER

FLOAT TREE

Fig. 9

Fig. 10

SK2434F

SK2504

SK2415

Fig. 11

Timed Dosing Applications

Fig. 8

5" MIN.

8" MIN.

LOW LEVEL CUTOUT

HIGH WATER ALARM

TIMER OVERRIDE

26.5" MAX.

TIMED DOSING

7.5" MIN.

(1" ADDED FOR SAFETY)

SEPTIC TANK MIN. INLET HEIGHT 40"

TOP OF FLOAT TREE

NYLON CABLE TIE

TOP OF FILTER HOLDER

SK2434E

If using a timed dosing panel, the oats should be set as follows:

Timed dosing without redundant off (see Fig. 8). Timed dosing with

redundant off (see Fig. 9).

If the system is dosing a collection system drain eld, media lter,

wetland or some other secondary wastewater treatment system, the

ideal dosing pattern should be known and applied.

The alarm must be activated at or before the point when the efuent

level reaches the bottom of the inlet pipe.

Record the actual settings measured from the top of the oat tree in

the table provided for future reference.

Float switch distance from top of the oat tree w/o redundant off.

Alarm - Black (below or even w/ bottom of inlet)

Timer override - Gray (varies)

Low level cutout - Gray (maximum 26½")

Float switch distance from top of the oat tree with redundant off.

Alarm - Black (below or even w/ bottom of inlet)

Timer override - Gray (varies)

Low level cutout - Gray (varies - maximum 25½")

Redundant off - Black (maximum 30½")

Small dimension oat switches are recommended

in all applications to prevent hang-ups.

13. Measure and mark all oat locations on the oat tree. Install the

cord holders on the oat tree. Place one at each marked location

rotating them approximately 90° apart in two quadrants (see Fig.

10).

14. Unpack variable level oat switches from system. Remove and

discard any oat holders/clamps attached to oat switch cords. Cut

any piggyback plugs from any oat switches. Measure 3½” from the

oat switch on the cord and mark this spot. Using the appropriate

oat diagram section (see Figs. 6, 7, 8 & 9), assemble each oat

cord through the oat holder and hand tighten (see Fig. 11).

15. Secure oat cords to top of the oat tree to prevent hang-ups (see

Fig. 10).