Installation Sheet

ManualsBrandsClarke ManualsPlumbingSparta 60" Soaking Bathtub for Three Wall Alcove Installation with Left Hand Drain Location and Integral Skirt - Less Drain Assembly

INSTALLATION & OPERATING

INSTRUCTIONS FOR LUXURY BATHTUBS

SAVE THIS MANUAL: RETAIN FOR CONSUMER’S USE.

READ THESE INSTRUCTIONS COMPLETELY BEFORE INSTALLING THE PRODUCT: IF YOU

HAVE ANY QUESTIONS CALL 1-817-796-5186.

YOU MUST FOLLOW ALL INSTRUCTIONS IN THIS MANUAL:

FAILURE TO DO SO WILL RESULT IN YOUR ASSUMPTION OF LIABILITY. FAILURE TO

COMPLY WITH ALL INSTRUCTIONS CAN RESULT IN PRODUCT DAMAGE AND PERSONAL

INJURY.

THIS PRODUCT COMPLIES WITH MANY NATIONALLY RECOGNIZED STANDARDS SUCH AS:

ANSI Z124.1- 9, ASME A112, IAPMO AND UL 1795. YOU ARE RESPONSIBLE FOR ANY LOCAL

CODES THAT MAY APPLY.

THIS PRODUCT IS DESIGNED TO BE INSTALLED BY A LICENSED TRADESMEN.

LICENSED PLUMBERS AND ELECTRICIANS SHOULD BE EMPLOYED TO INSURE PROPER

INSTALLATION. INSTALLERS ASSUME ALL LIABILITY FOR THE CORRECT INSTALLATION

PROCEDURES.

Only accessories authorized by the manufacturer should be used with this product.

THIS PRODUCT IS DESIGNED FOR RESIDENTIAL USE AND USE BY HEALTHY INDIVIDUALS.

IMPORTANT SAFETY INSTRUCTIONS:

WARNING! WHEN USING THIS PRODUCT, BASIC PRECAUTIONS

SHOULD ALWAYS BE FOLLOWED. READ AND FOLLOW ALL

INSTRUCTIONS PERTAINING TO RISK OF FIRE, ELECTRIC SHOCK,

OR INJURY TO PERSONS

DANGER: TO REDUCE THE RISK OF INJURY, DO NOT PERMIT CHILDREN TO USE THIS PRODUCT

UNLESS THEY ARE CLOSELY SUPERVISED AT ALL TIMES.

Clarke Products

REVISION 11-04-2009

Summary of content (10 pages)

PAGE 1
Clarke Products REVISION 11-04-2009 INSTALLATION & OPERATING INSTRUCTIONS FOR LUXURY BATHTUBS SAVE THIS MANUAL: RETAIN FOR CONSUMER’S USE. READ THESE INSTRUCTIONS COMPLETELY BEFORE INSTALLING THE PRODUCT: IF YOU HAVE ANY QUESTIONS CALL 1-817-796-5186. YOU MUST FOLLOW ALL INSTRUCTIONS IN THIS MANUAL: FAILURE TO DO SO WILL RESULT IN YOUR ASSUMPTION OF LIABILITY. FAILURE TO COMPLY WITH ALL INSTRUCTIONS CAN RESULT IN PRODUCT DAMAGE AND PERSONAL INJURY.
PAGE 2
WARNING: RISK OF ACCIDENTAL INJURY OR DROWNING; CHILDREN SHOULD NOT USE HY DROMASSAGE BATHTUB WITHOUT ADULT SUPERVISION; WARNING: RISK OF ACCIDENTAL INJURY OR DROWNING; DO NOT USE HYDROMASSAGE BATH- TUB UNLESS ALL SUCTION GUARDS ARE INSTALLED TO PREVENT BODY AND HAIR ENTRAPMENT; WARNING: TO AVOID INJURY, EXERCISE CARE WHEN ENTERING OR EXITING THE HYDROMASSAGE BATHTUB; WARNING: RISK OF ACCIDENTAL INJURY OR DROWNING; DO NOT USE DRUGS OR ALCOHOL BEFORE OR DURING THE USE OF A HYDROMASSAGE BATHTUB EQUIPPE
PAGE 3
UNPACKING THE UNIT 1. Inspect the carton. 2. If you note carton damage, take a picture if possible and contact the deliverer. 3. Immediately inspect the unit for damage even if there is no visible carton damage. Once the unit is installed and there is surface damage visible, we will assume it was caused by the installer if you do not report it immediatly. Installers are responsible for damage that occurs once the unit is placed in its assigned location. 4. Inspect the plumbing for any loose fittings. 5.
PAGE 4
MODEL LENGTH WIDTH HEIGHT HEIGHT TO DECK TO LIP “A” “B” T3060SKL/R 60” 30” 16 1/2 ” 15 1/2 ” 9 1/2 ” 15” T3260, W3260, A3260, WA3260 60” 32” 20 1/2 ” 19” 12 3/4 ” 16” T3260N, W3260N, A3260N, WA3260N 60” 32” 19 1/2 ” 18” 10” 16” T3260SKL/R, W3260SKL/R, 60” 32” 19 3/4 ” 18 3/4 ” 9 1/2 ” 16” T3660, W3660, A3660, WA3660 60” 36” 20” 18 1/2 ” 6 3/4 ” 18” T3660SKL/R, W3660SKL/R, 60” 36” 19 3/4 ” 18 3/4 ” 9 1/2 ” 18” T3672, W3672, A3672, WA3672 72” 36” 20” 18 1
PAGE 5
L DO H W B L A W B L A W B L C Illustration D A WALL BOARD W TILE SILICONE HEIGHT TO LIP AIR GAP 1/4” OR MORE HEIGHT TO LIP STUD 1” X 4” JOIST Illustration F SETTING COMPOUND Illustration E Illustration G INSTALLATION PLANNING AND PREPARATION 1. NEVER LIFT THE TUB BY THE PLUMBING. Doing so can result in leaks. 2. Check if the floor is level and of good quality. An uneven floor may impede proper installation of the product.
PAGE 6
INSTALLATION PROCEDURES: Installation must comply with local and national codes. WARNING: When installing Whirlpools, Air, or Total Massage Baths, observe basic precautions, including the following: • DANGER: RISK OF ELECTRICAL SHOCK! Connect only to a separate circuit protected by a ground fault circuit interrupter (GFCI) • Installation must provide access for servicing pump/motor. 1. Install tub waste/ overflow fitting according to instructions provided. 2.
PAGE 7
TESTING THE BATH 1 Installation is not complete until the bath has been water tested. All baths are operationally tested at the factory and certified to be free of leaks. Transportation and handling may result in leaks developing. It is necessary to test the bath while there is access to all sides of the bath. 2 The unit should be both static and operationally tested. i. Seal the drain and fill the tub to a normal level. ii. Allow the tub to stand for 5 minutes and then inspect all plumbing for leaks. iii.
PAGE 8
JET OPERATION AND ADJUSTMENT The jets can be easily adjusted by pointing the jet-nozzle in the desired direction. The strenght of the waterflow and air induction can be regulated through twisting the jet-nozzle. Twisting the nozzle clockwise will decrease the waterflow and finally completly turn off the waterflow of that particular jet. If the nozzle is twisted counter clockwise then the waterflow will increase up to its maximum flow.
PAGE 9
TOTAL MASSAGE BATHS Adjusts the variable water-flow of the jets up or down Switches the jet-pump on or off Jets Blower Switches the air-blower on or off Speed Speed Switches from continuous to wave action water-flow Wave Wave Adjusts the variable air-flow of the blower Illustration K Switches from continuous to wave action air-flow Total Massage units are a combination of whirlpool and air massages.
PAGE 10
Clarke Products LIMITED WARRANTY All Clarke Products Whirlpools and Bathing Systems are warranted in accordance with the following Limited Warranty: Clarke Products Whirlpools and Bathing Systems are warranted against defects in material and workmanship from the date of the first consumer purchase. GENERATION and Simple pleasures warranty is 2 years. This Warranty shall apply to defective acrylic surfaces which crack, fade or blister, and any defect in whirlpool and bathing system components.