Specifications

6
OPERATION (Ref. Fig. 2)
NOTE: If you intend using your compressor for spraying, read also the ‘Helpful Hints on
Spraying” booklet - supplied with the machine.
1. Check that the mains voltage corresponds with that shown on the data sticker
on the crankcase cover of the machine.
2. Ensure that the ON/OFF knob is in the ‘OFF’ (0) position, i.e. pushed DOWN,
then plug in and switch on at the mains supply.
3. To start the compressor pull UP the ON/OFF knob to the ‘ON’ (I) position - the
motor should start immediately.
Fig. 2
ON/OFF Knob
Air Filter
Outlet Pressure
Gauge
Quick Release
Coupling
Tap
Pressure
Regulator Knob
Air Tank
Pressure Gauge
RAIDER 60
RAIDER 120
IMPORTANT: When running for the first time....allow the motor to run for a
full 10 minutes, with the drain valve fully open.
SPECIFICATIONS
Rotational Speed.................................................. 2850 rpm
Max. Pressure ..................................................... 10 bar (145psi)
Air Displacement .................................................. 400L/min (14 cfm approx)
Electric Motor ..................................................... 3HP
Nominal Rating ..................................................... 13.5 Amps
Receiver ..........Raider 60 .................................... 50 Ltr
Raider 120 .................................. 100Ltr
Compressor Oil ..................................................... CLARKE SAE 40
Fuse Rating ............................................................ 20 amps
Part No.............Raider 60 .................................... 2320600
Raider 120 .................................. 2320610
Duty Cycle ............................................................ S1
ACCESSORIES
Your Clarke Raider Air Compressor can be used in conjunction with a range of
optional accessories for inflating tyres, air brushing, stapling, blowing and many
other uses. For details contact your local accessory stockist. Kits are available
from your Clarke dealer which are ideal for almost all applications.
Illustrated - KIT 1000, Part Number 3110155
Please note that the details and specifications contained herein, are correct at the time of going to
print. However, CLARKE INTERNATIONAL reserve the right to change specifications at any time without
prior notice. Always consult the machines’ data plate,
11
Should you experience any difficulties obtaining accessories, please contact the
Clarke sales department (telephone [phone]) for details of your nearest
dealer.
(This machine may be run continuously)