Specifications

Lower
Neutral
Raise
7
9
10
8
Fig. 3
Fig. 4
Fig. 5
OPERATING INSTRUCTIONS
Before operating the truck, ensure you have read and understood the instructions in this
manual, paying particular attention to the safety precautions.
Familiarise yourself with the controls, i.e; raise and lower the forks without any load, practice
steering the empty truck to understand how the truck reacts.
To raise the forks, push the trigger down until it latches, then slowly pump the handle
backwards and forwards and watch the forks lift, once the forks are in their highest position,
put the trigger into the central position (neutral), to lower the forks, gently pull the trigger
upwards, or push the foot pedal down the more the trigger is pulled up or the foot pedal is
pushed down, the faster the forks will lower,
NOTE:
The forks will drop much faster when a load is on the forks, also the heavier the
load the faster still the rate of descent.
!. Ensure the pallet to be moved does not exceed the maximum weight for the truck.
2. Make visual checks to ensure the load is secure and will not topple off when lifted,
also check the pallet is not broken etc.
3. Once satisfied all is ok, proceed as follows.
a) With the forks in their lowest position, Slowly push the truck under the load to be
moved, try to position the truck so that the centre of gravity is in the middle of the
forks. In the event this is not possible the rated capacity is reduced, ie; the truck is
designed and built to lift a maximum load of 2500 kg spread over both forks. Take
care that the fork rollers are not sitting on any pallet cross member etc.
-7-