Specifications

ASSEMBLY Figures in brackets refer to Index Nos in parts list on pages 9-12
Your new Pallet truck is delivered with the handle removed, To fit the handle proceed as
follows;
1. Remove one roll pin, item 1, Fig. 1 (117) from shaft, item 2, Fig. 1 (118) and keep safe
for reuse later.
2. Remove shaft from pump body item 4, Fig. 2.
3. Insert Handle tube with warning label on top and trigger on R/H side, item 3, Fig.2
(108) at position A, Fig. 1, Note ; handle needs to be held at an angle of approx 45º
in order to fit the shaft, connect handle tube to pump body by sliding the shaft,
item 2, Fig. 1, back into pump body and handle tube.
4. Turn shaft so that the roll pin is vertical. DO NOT push fully home yet.
5. Pass the roller chain, item 5, Fig. 2 (115), through the centre hole in shaft, Locate
Fig. 1 Fig. 2
8. Try raising the forks by pushing the trigger, item 8, Fig. 3 down until it latches. Pump
handle backwards and forwards, forks should lift. and should remain in up position.
If forks drop without raising the trigger up to the lowering position, proceed as follows.
1a) Loosen hexagonal nut, item 10, Fig. 5 (134) and turn screw, item 9, Fig. 5 (133)
anticlockwise a little.
2a) Repeat step 7, again if forks drop, turn screw a little more, keep repeating this
procedure until forks stay up until, either the trigger or foot pedal is operated to
lower the truck. If forks do not lower when operating the trigger or foot pedal, turn
-6-
WARNING!
MAXIMUM LOAD - 2500KG