Specifications

CLEANING AND MAINTENANCE

WARNING!

MAKE SURE THAT THE PUMP IS DISCONNECTED FROM THE MAINS SUPPLY

BEFORE CLEANING, OR PERFORMING ANY MAINTENANCE.

• These pumps should require no maintenance other than regular cleaning. If the

pump starts to show signs of wear or damage, contact your CLARKE dealer for

advice.

• Do not attempt to repair the pump yourself, repairs must be carried out by your

CLARKE dealer, or contact the CLARKE Service Department, on 020 8988 7400.

• Check the pump regularly to ensure the base is clear of leaves or other debris.

Replacing the Impeller

1 Pull off the base cover.

2 Remove the 3 screws on the base of the pump, and remove the cover.

3 Use a small flat headed screwdriver to remove the circlip.

4 Remove the impeller from the shaft.

5 Replace with a new impeller and lock it in place using the circlip.

6 Replace the base and use the 3 screws to secure. and push on the base cover.

Circlip