Operator`s manual

Clarke
®
Operator's Manual -MINI MAX Page -9-
Figure 7
How To Handle the Packed Machine
The machine is packed in a specific package provided on
a pallet so that it can be moved with a forklift.
WARNING: The packages cannot be placed on
top of each other.
How to Unpack the Machine
1. Remove the outer package.
2. The machine is fixed on the pallet with banding straps
and wooden blocks to prevent movement during
shipment. Remove the bands and blocks.
3. The MINI-MAX is shipped with the batteries already
installed. The machine can be driven off of the pallet if
the operator is thoroughly familiar with its operation.
4. Lower the ramp. Release the parking brake and
remove the machine. Avoid violent blows to the base
unit.
4. Keep the pallet for future transport necessities.
How to Install the Batteries
WARNING: The batteries are heavy. Lifting
batteries without help could result
in an injury. Get help to lift the
batteries.
WARNING: Working with batteries can be
dangerous. Always wear eye
protection and protective clothing
when working near batteries. NO
SMOKING!
WARNING: Hydrogen gas is formed during the
charging operation and is explosive.
Only charge batteries in a well
ventilated area with the seat base
lifted.
WARNING: Pulling out the charger plug, with
the timer on, will cause an arc and
must be avoided.
The batteries are fitted in the appropriate compartment
under the seat and under the recovery tank (figure 6). The
MINI-MAX uses six - 6 volt batteries. They must be
handled by using appropriate lifting equipment suitable
for the weight and for the coupler system. For
maintenance and daily recharge of the batteries, it is
necessary to follow all instructions given by the
manufacturer.
For Battery Installation follow these steps (See figure 6):
1. Make sure that the key switch is in the “OFF” position
and the parking brake is set.
2. Lift and rotate the base support of the seat forward.
3. Lean the seat on to the steering wheel.
4. Lift the front of the recovery tank and rotate it towards
the rear until it locks in place.
5. Put the batteries into position and connect the battery
cables as shown in figure 7.
6. Join the connector from the battery pack to the
machine connector (see figure 8).
How To Prepare the Machine For Operation
Figure 8
Figure 6
7. Unlatch the recovery tank support and
carefully rotate it forward to the normal
operating position.
8. Lower the base support of the seat.
NOTE: Charge the batteries before using.