Operator`s manual

Clarke
®
Operator's Manual -MINI MAX Page -19-
Do These Procedures When You Begin Your Work
Period
1. Make sure the key switch is in the “OFF” position.
2. Disconnect AC power from battery charger (follow
charger instructions).
3. Disconnect the connector on the battery charger from
the battery pack connector.
4. Join the connector from the batteries to the machine
connector.
5. Make sure the filter screen (1) to the vacuum motor is
clean and installed properly in the recovery tank (see
figure 38).
6. Make sure the recovery tank lid is in place and has
been tightened (see figure 39).
7. Close and secure the lower cleaning port cover on the
recovery tank (see figure 40).
8. Make sure that the plug in the recovery drain hose is in
place and has been tightened (see figure 41).
9. Make sure that the brushes/pads are in position and
installed correctly.
10. Make sure the brush housings and skirts are in
position on the brush head.
11. Check the installation of the squeegee and squeegee
hose.
How to Clean a Floor
WARNING: Water solutions or cleaning
materials used with this type of
machine can leave wet areas on
the floor surface. These areas
can cause a dangerous condition
for the operator or other persons.
Always put CAUTION signs near
the area you are cleaning.
To clean a floor follow this procedure:
1. Turn the key switch to the “OFF” position and set the
parking brake.
2. Put the water and a cleaning chemical in the solution
tank.
3. Sit on the driver seat. NOTE: The machine will not
traverse if the operator is not properly seated.
4. Release the parking brake.
5. Turn the key switch “ON”. NOTE: The key switch
turns on the battery and hour meter displays.
How To Operate the Machine
Figure 38
Figure 39
Figure 40
Figure 41
1