User guide

10
ASSEMBLY
FITTING THE CONTROL ARMS
1. Position the control lever into the
side of the arm assembly as
shown.
• Make sure the control lever
goes into
the slot on the arm
assembly.
2. Lock the arm assembly in to
position with the bolt, large
wash
er, small washer and nut
supplied.
3. Follow the same steps to install the
other ar
m assembly.
FITTING THE WHEELS
1. Slide one of the wheels onto the
axle followed by a washer.
2. Slide the axle through the holes on
the frame a
s shown on the right.
3. Slide on a second washer and
then the second wheel onto the
axle.
• Make sure the wheel is on, the
right way round (the notch
indicated should be facing
outwards).
4. Add a final washer and secure
using the split pin provided.