Specifications

Extra Precautions for Log Splitters
Extra special care is required when using this powerful tool to safeguard yourself and that of
others around you.
• Before using the log splitter, check for fluid leaks. Be sure the tool and the work area
around it is clean and free of oil spills. Hydraulic fluid can create hazards, causing you
to slip and fall, your hands to slip while using the machine, and it is also a potential fire
hazard.
• Hydraulic Systems: Never operate this tool if there is a potential hazard due to leaking
hydraulic fluid.
• Electrical Safety: Never operate this tool in wet conditions.
• Physical Hazards: The very nature of log splitting will produce splinters. When operating
log splitters, always ensure approved safety gloves, shoes,
and eye protection is worn.
• NEVER tamper with the log splitter or attempt to operate
the machine without covers fitted.
• NEVER work with the machine on the ground. This is not
only an uncomfortable working position but it can also be
dangerous because the operator has to bend towards
the machine, and thus risk being struck by chips or debris.
• NEVER try to split logs larger than those indicated in Fig. 2.
This could be dangerous and may damage the machine.
• Do not allow split logs to accumulate, always clean up as
you work, accumulated split logs and wood chips can
create a hazardous work environment.
• The operator must take all necessary precautions to minimize
the risk of accidental damage or injury due to wood being
ejected from the machine.
• The operator must operate the machines’ controls with both hands without using
other makeshift systems, i.e. wedging control levers down etc.
• For the best and safest use, the logbuster MUST be used on a raised surface, of sufficient
height, so that when the logbuster is mounted, the main bed of the machine is no
higher. or lower, than the extended arms of the operator,
without the operator having to bend forward (see Fig. 1).
• The surface must be perfectly level to prevent the machine
from moving during operation, and the area must be free
from any objects that could prevent complete freedom of
movement for the operator whilst working.
• The machine must always be used by ONE OPERATOR
ONLY. Nobody must be allowed to use the log splitter
unless they have read the instruction manual thoroughly
and have been instructed in its use. The machine must
be used by adults only. Check that the logs to be split
are free from nails or wire, which may fly up or damage the machine. The ends of the
logs must be cut square. Branches must be cut off flush with the trunk.
• Never attempt to split two logs at once; one may be ejected with possibly serious
damage.
• Split wood in the direction of the grain. Do not attempt to split a piece of wood across
the grain as this could seriously damage the machine.
Fig. 1
Fig. 2
520mm
250mm
-5-