Instruction manual

4
USAGE AND CARE
1. Do not force the log splitter. It will do the job better and safer at the rate for which it was
designed.
2. Disconnect the plug from the power source before making any adjustments, changing
accessories, or storing the log splitter. Such preventive safety measures reduce the risk of
starting the log splitter accidentally.
3. Storethe log splitter out of the reach of children and do not allow persons unfamiliar with
log splitters or these instructions to operate the log splitter. Log splitters are dangerous in
the hands of untrained users.
4. Maintain the log splitter. Check for misalignment or binding of moving parts, breakage of
parts and any other condition that may affect the log splitters operation. If damaged,
have the log splitter repaired before use. Many accidents are caused by poorly
maintained power tools.
5. Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp cutting
edges are less likely to bind and are easier to control.
SERVICE
1. Have your power tool serviced by a qualified repair person using only identical
replacement parts. This will ensure that the safety of the power tool is maintained.
ADDITIONAL SAFETY RULES FOR LOG BUSTERS
Extra special care is required when using this powerful tool to safeguard yourself and
that of others around you.
1. Never tamper with the log buster or attempt to operate the machine without covers
fitted.
2. Never work with the machine on the ground. This is not
only an uncomfortable working position but it can also
be dangerous because the operator has to bend
towards the machine, and thus risk being struck by chips
or debris.
3. The log buster must be used on a raised surface, of
sufficient height, so that when the log buster is mounted,
the main bed of the machine is no higher or lower, than
the extended arms of the operator, without the operator
having to bend forward.
4. Do not allow split logs to accumulate, always clean up as you work, accumulated split
logs and wood chips can create a hazardous work environment.
5. The operator must operate the machines controls with both hands without using other
makeshift systems, i.e. wedging control levers down etc.
6. The machine must always be used by one operator only. Nobody must be allowed to use
the log buster unless they have read the instruction manual thoroughly and have been
instructed in its use. The machine must be used by adults only. Check that the logs to be
split are free from nails or wire, which may fly up or damage the machine. The ends of the
logs must be cut square. Branches must be cut off flush with the trunk.
7. Never attempt to split two logs at once; one may be ejected with possibly serious
damage.