5 IN 1 JUMP START MODEL NO: JS5IN1 PART NO: 6240005 OPERATION & MAINTENANCE INSTRUCTIONS LS0810
INTRODUCTION Thank you for purchasing this CLARKE product. Before attempting to use this product, please read this manual thoroughly and follow the instructions carefully. In doing so you will ensure the safety of yourself and that of others around you, and you can look forward to your purchase giving you long and satisfactory service. GUARANTEE This product is guaranteed against faulty manufacture for a period of 12 months from the date of purchase.
GENERAL SAFETY RULES WARNING: ALL LEAD ACID BATTERIES GENERATE HYDROGEN GAS DURING NORMAL OPERATION. THIS PROCESS INCREASES DURING A PERIOD OF RAPID DISCHARGE, SUCH AS WHEN USING FOR JUMPSTARTING. WARNING: HYDROGEN GAS AND BATTERY ACID (SULPHURIC ACID) CAN BE EXPLOSIVE, CORROSIVE TO SKIN, EYES AND HAIR, DAMAGING TO CLOTHING AND METALS, FLAMMABLE, POISONOUS TO BREATHE. 1. Although the unit is water resistant and may be used outdoors, DO NOT leave it exposed to the elements.
14. If battery acid comes into contact with the eyes, flush the eyes with clean water continuously and seek medical help. 15. Always ensure that there is air circulating around the unit when in use. 16. Never allow the negative and positive leads on this unit, to touch each other or to touch the same metal object. 17. Ensure the vehicle battery posts and battery clamps are perfectly clean before use. 18.
SAFETY SYMBOLS Class II appliance Always read instructions before use Electrical Hazard due to exposed live terminals Chemical Hazard from battery acid USB Port - + Live centre pin Suitable for indoor use only (refers to mains adaptor only) Subject to Waste Electrical & Electronic Directive 5 Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.
OVERVIEW NO DESCRIPTION NO DESCRIPTION 1 12V Cigarette Plug Socket 10 Charging Indicators 2 Pressure Gauge 11 USB Sockets 5V DC Outlet 3 Air Compressor On/Off Switch 12 Air Compressor Hose Compartment 4 Worklight 13 Charging Jack Socket 5 Reverse Polarity Warning Light 14 Inverter Power Indicator Light 6 Worklight On/Off Switch 15 Inverter On/off Switch 7 Voltage Test Button 16 Inverter Status Lights 8 Voltage Meter 17 Fuse 9 230V AC Output Socket 6 Parts & Service: 020
CHARGING THE BATTERY Two means of charging the battery are provided. 1. Via a 230V supply, using the 230V charger with cable and DC plug provided, shown as ‘A’. 2. Via a 12V vehicle supply using the cigar lighter adapter with cable and plug provided, shown as ‘B’. • Using a 12V vehicle supply, the battery will not charge to its maximum. TO ENSURE MAXIMUM LIFE FROM THE BATTERY. • Charge this unit before using it for the first time.
USING THE 12V ADAPTOR WARNING: BEFORE USING THE DC POWER SOURCE FROM THE CAR CIGARETTE SOCKET CHECK THAT ITS FUSE RATING IS RATED AT 15A OR HIGHER. 1. Ensure the vehicle is not running. 2. One end of the twelve volt lighter plug lead should be plugged into one of the two cigarette lighter sockets. 3. The other end should be inserted into the vehicle lighter socket. 4. The engine should then be started.
OPERATION USING THE USB POWER SUPPLY 1. Insert the USB cable into one of the USB sockets on the side of the unit. 2. Press the USB side of the INVERTER/ USB switch as shown. • This will supply a maximum 5V at 500mA. USING THE WORKLIGHT 1. Use the light switch on the side of the unit to turn the worklight on. 9 Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.
JUMP STARTING WARNING: IT IS POSSIBLE THAT SOME ELECTRONIC EQUIPMENT COULD BE DAMAGED BY JUMP STARTING. ALWAYS CHECK WITH THE CAR MANUFACTURER’S HANDBOOK TO DETERMINE WHAT PRECAUTIONS IF ANY SHOULD BE TAKEN. ALWAYS carry out the following preliminary checks before connecting the Jumpstart to the battery: • Switch off the vehicle ignition and ALL ancillary equipment - lighting, radio etc. • Ensure the vehicle battery is rated at 12V and is not damaged in any way. • Ensure the area is well ventilated.
USING THE AIR COMPRESSOR 1. Open the compartment door on the side of the unit to reveal the air hose. 2. Extend the air hose fully. 3. Attach the air hose to the tyre by pushing the connector down firmly on the tyre adapter and locking in place by turning the connector locking lever through 90 degrees. 4. Switch the air compressor ON using the switch shown. • The air pressure will be indicated by the pressure gauge. • Pump up the tyre to the required pressure.
USING THE 12 VOLT POWER SUPPLY Two cigarette lighter type sockets allow connection to DC electrical equipment via a standard DC adapter. WARNING: BE AWARE THAT A FULLY CHARGED 12V BATTERY CAN HAVE AN OUTPUT OF APPROX.13.5V. CONSULT THE APPLIANCE HANDBOOK TO ENSURE IT IS SAFE TO OPERATE FROM A 12V BATTERY. USING THE INVERTER WARNING: WHEN USING THE INVERTER FUNCTION THE JS5IN1 AND WHATEVER YOU ARE POWERING MUST BE INSIDE AWAY FROM ANY RAIN OR MOISTURE.
MAINTENANCE CLEANING • Wipe the body of the unit clean using a soft damp cloth. • Do not use harsh abrasives to clean this product. SERVICE AND REPAIR • All servicing and repair must be carried out by qualified service technicians. STORAGE • When not in use, store in a safe dry place. SPECIFICATIONS Model Number JS5IN1 Battery Capacity 12V, 18AH USB Output 5V @ 500mA Air Compressor (Max Pressure) 260 PSI Dimensions (L X W X H) 345 x 253 x 267 mm Weight 10.
DECLARATION OF CONFORMITY 15 Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.
