Specifications

Lighting the Heater
WARNING!
Before starting the heater, you MUST ensure that the minimum ventilation
requirements are observed to avoid the risk of carbon monoxide poisoning.
1. Ensuring there is sufficient gas, and that it is correctly connected and leak
free - turn on the gas supply and check all fittings and connections for gas
leaks using a mild soap and water solution. NEVER use a match to check for
gas leaks.,when satisfied, open the valve on the gas cylinder,
NOTE: The heater, has a fixed, regulated gas flow
2. Press and hold the Control Valve plunger,
shown in Fig.2, whilst continually pressing
the piezo electric button until the burner
ignites.
Once the burner ignites, keep the button
pressed for one (1) minute or until the
burner stays lit after it is released.
WARNING!
DO NOT face the heater element when
starting - ALWAYS stand to one side.
NOTE: If a new gas cylinder has been
connected, it may take some time for the gas
line to be purged of air. Press the Piezo electric
button every 10-15 seconds until it ignites.
2A. Alternatively, hold a lit taper to the burner face while pressing and holding
the control valve button. After the burner ignites, keep button pressed for
one (1) minute or until the burner stays lit after releasing button.
Fig.2
Fig.3
WARNING!
When lighting
burner with a
taper, light at
bottom of
screen. Not at
the orifice.
8