Specifications

8
Parts & Service: 020 8988 7400 / E-mail: [e-mail] or [e-mail]
UNPACKING AND ASSEMBLY
Unpack your generator and make sure the following items are present.
Should there be anything missing or damaged in transit contact your Clarke
dealer immediately.
BEFORE USING THE GENERATOR
IMPORTANT: Generators should ALWAYS be earthed. Make sure you ground
(earth) the generator.
Before using your generator check that:
• The generator is in good condition and free from any damage.
• The generator is clean and free from fuel or oil spillage.
• The generator is correctly positioned for use (See page 4).
• The fuel system and connectors are intact and there is no leakage.
1 x Generator 1 x 12V Battery Charging Lead
1 x Spark Plug Box Spanner 1 x Petrol Tank Cap
1 x Phillips No.1 Screwdriver 1 x Handle + Fixings Pack
WARNING: DO NOT CONNECT TO A BUILDINGS ELECTRICAL SYSTEM
UNLESS AN ISOLATION SWITCH HAS BEEN INSTALLED BY A QUALIFIED
ELECTRICIAN.
WARNING: CONNECTIONS FOR STANDBY POWER TO A BUILDINGS
ELECTRICAL SYSTEM MUST BE MADE BY A QUALIFIED ELECTRICIAN AND
MUST COMPLY WITH ALL APPLICABLE LAWS AND ELECTRICAL CODES.
IMPROPER CONNECTIONS CAN ALLOW ELECTRICAL CURRENT FROM THE
GENERATOR TO BACK FEED INTO THE UTILITY LINES. SUCH BACK FEED
MAY ELECTROCUTE UTILITY COMPANY WORKERS OR OTHERS WHO
CONTACT THE LINES DURING A POWER OUTAGE, AND WHEN POWER IS
RESTORED, THE GENERATOR MAY EXPLODE, BURN, OR CAUSE FIRES IN THE
BUILDINGS ELECTRICAL SYSTEMS.