Operator`s manual

Page 8 Clarke

Ext -311 Owner's Manual

INSTRUCTIONS FOR CONNECTION TO THE

POWER SUPPLY AND ELECTRICAL GROUND - 230 V

CAUTION: This machine will operate only on an AC

frequency and on the specified electrical

voltage shown on the nameplate. Make

sure you have the correct frequency and

voltage before connecting the power cord

to an outlet.

This machine must be connected to an electrical ground circuit

in order to protect the operator from electric shock. This

machine has an approved power cord with two main conductors

and one earthing conductor. Connect the plug to the type of

receptacle shown in figure 6. The green and yellow conductor

in the cord is the ground wire. Never connect this wire to any

terminal other than the ground terminal.

WARNING: Always use this machine with an AC

three-conductor electrical system con-

nected to the electrical ground. Replace

any worn, cut or damaged cords. Re-

place any damaged plugs, receptacles, or

connector bodies. Do not move the

machine over an electrical cord. Always

lift the cord over the machine.

Extension Cords

Use only an approved extension cord with two main conductors,

and one earthing conductor. This machine has a power cord

with a wire size of 1.5mm

WARNING: If you use an extension cord, use one that

has a minimum wire size of 1.5mm

. Be

sure your extension cord is no longer

than 15 meters. Do not join two extension

cords.

WARNING: Do not cut, remove or break the ground

terminal. Do not try to fit a three-terminal

plug into a receptacle or connector body

that does not fit the plug. If the receptacle

or connector body does not fit the plug,

see your authorized Clarke Dealer to get

an authorized person to make the con-

nection.

Figure 6

Pin Earthing Contact

Side Earthing Contact

European Plug