Operator`s manual

Page 8 CLARKE TECHNOLOGY EXT 515 Operator's Manual
INSTRUCTIONS FOR CONNECTION TO THE
POWER SUPPLY AND ELECTRICAL GROUND - 230 V
CAUTION: This machine will operate only on an AC
frequency and on the specified electri-
cal voltage shown on the nameplate.
Make sure you have the correct fre-
quency and voltage before connecting
the power cord to an outlet.
This machine must be connected to an electrical ground circuit
in order to protect the operator from electric shock. This
machine has an approved power cord with two main conductors
and one earthing conductor. Connect the plug to the type of
receptacle shown in figure 6. The green and yellow conductor
in the cord is the ground wire. Never connect this wire to any
terminal other than the ground terminal.
WARNING: Always use this machine with an AC
three-conductor electrical system con-
nected to the electrical ground. Re-
place any worn, cut or damaged cords.
Replace any damaged plugs, recep-
tacles, or connector bodies. Do not
move the machine over an electrical
cord. Always lift the cord over the ma-
chine.
Extension Cords
Use only an approved extension cord with two main conduc-
tors, and one earthing conductor. This machine has a power
cord with a wire size of 1.5mm
2
.
WARNING: If you use an extension cord, use one
that has a minimum wire size of 1.5mm
2
.
Be sure your extension cord is no longer
than 15 meters. Do not join two exten-
sion cords.
WARNING: Do not cut, remove or break the ground
terminal. Do not try to fit a three-termi-
nal plug into a receptacle or connector
body that does not fit the plug. If the
receptacle or connector body does not
fit the plug, see your authorized Clarke
Dealer to get an authorized person to
make the connection.
Figure 6
Pin Earthing Contact
Side Earthing Contact
European Plug