Specifications

Common sense applies to the use of both this and any other electric power tool.
In particular we bring the following points to your attention.
ALWAYS keep the work area clean, well lit and uncluttered.
ALWAYS place the machine on a firm steady base and at a comfortable
working height.
Apart from the water trough which is provided to wet the cutting disk,
ALWAYS check to ensure that all other parts of the machine and the
surrounding work area are kept dry.
ALWAYS use in a well ventilated area. Never operate the saw in the presence
of inflammable vapours.
ALWAYS keep children well clear of the work area at all times.
ALWAYS examine the cutting disk before use and replace if worn.
ALWAYS allow the motor freedom, so that the cutting disk will be cutting at, or
close to its maximum speed.
ALWAYS use Clarke general purpose safety goggles to protect the eyes from
flying particles.
ALWAYS take suitable precautions in respect of loose clothing, long hair and
jewellery, as these are potential hazards which could get caught up in the
moving parts of this high speed machine.
ALWAYS use a Clarke face mask to prevent inhalation of any dust which may
be present.
ALWAYS turn off the power supply before making any adjustments to the
machine.
The use of work gloves is recommended, providing these allow you to retain
sufficient feel and sensitivity whilst operating the machine.
NEVER force the cutting disk if it is reluctant to cut properly or tends to slow down.
NEVER use this machine for cutting metal or vegetable matter. This machine
for cutting stone, ceramics, marble and similar hard material ONLY.
NEVER attempt to repair the mains cable. If it, or any part of the switch assembly
becomes damaged, then it must be replaced.
NEVER apply side thrust to the cutting disk. i.e. try to cut on one side of the disk
only.
NEVER operate this machine with the Disk Guard removed
GENERAL SAFETY PRECAUTIONS.