Service manual

Ref # Part No. Description Qty.

1 Screw, ¼-20 -

2 Washer, ¼ Lock -

3 52660A Coupler 1

4 45044A Motor 1

5 69189A Transaxle Gearbox Assembly 1

6 Pin, Dowel -

7 End Plate, Output -

8 Magnet and Housing Assembly -

9 Armature and Bearing Assembly -

10 Washer, #10 Lock -

11 Nut 10-32 -

12 Stud -

13 52940A Commutator End Bell & Brush Asm. 1

14 51202A Mount, Bushing 2

Torque #1 80 inch pounds

Torque #11 40-45 inch pound tooth nuts

#12 Loctite #262

NOTE: Transaxle unit is sealed. No lubrication required

CLARKE TECHNOLOGY Encore L20

Transaxle Repair Parts 4/01

(COUPLER)

3.06 dia.

Commutator Endbell and

Brush Assembly

Installation Instructions:

1. With motor still fastened to transaxle gearbox,

remove old endbell by backing off the two 10-

32 nuts and removing the lock washers. Slide

endbell off motor.

2. Assemble new commutator endbell and brush

assembly by sliding it over shaft and motor

studs until brush retaining clip bottoms out.

Holding endbell still, slide retaining clip out from

between the brushes and commutator. Push

the endbell on the rest of the way until endbell

casting bottoms on the motor frame. Replace

the lock washers and nuts and torque the nuts

40-45 in.-lbs.

Page -54- CLARKE TECHNOLOGY Operator's Manual -Encore S20/L20